This aero bonnet has three vents on the left and right sides of the bonnet. The vents are laid out in a flowing silhouette design, blending in with the CR-Z's innovative lines to create a fresh, urban atmosphere. Type MR1 uses twill carbon on the front and FRP on the back, type MR2 uses plain weave carbon on the front and FRP on the back, and type MR3 uses all FRP on both sides. The back is finished with a black gel coat, and the duct part is designed to prevent rain and debris from entering by adopting an inner protector, so it is safe even on rainy days and helps keep the engine room clean. The carbon bonnet type MR is reinforced on the back and is installed using the same installation method as the genuine product, with a bonnet striker. For safety reasons, when driving on the street, you can use it safely without a bonnet pin by using the genuine striker. However, when driving on a circuit or other sports, the bonnet is lightweight, so the bonnet lock may come off due to wind pressure, so we recommend using a bonnet pin for safety. We recommend UV-cut clear coating on the carbon bonnet to maintain its long-term gloss.
CR-Z Carbon Bonnet
This aero bonnet has three vents on the left and right sides. The vents are laid out in a flowing silhouette design, blending in with the innovative lines of the CR-Z to create a fresh, urban atmosphere. Type MR1 uses twill weave carbon on the front and FRP on the back, Type MR2 uses plain weave carbon on the front and FRP on the back, and Type MR3 uses all FRP on both sides. All products are made to order, so please inquire about delivery dates.
Price range: ¥79,000 through ¥130,000 Tax excluded
|
Carbon bonnet with twill carbon on the front and FRP on the back |
■This is a Type MR1 model with a twill carbon material on the surface and FRP on the back. |
|---|---|
|
Carbon bonnet with plain weave carbon on the front and FRP on the back |
■This is a Type MR2 model with plain weave carbon material on the surface and FRP on the back. |
|
All-FRP bonnet with FRP front and FRP back |
■This is a Type MR3 model that is made entirely of FRP, with FRP on the front and FRP on the back. |
■Installation is done using a bonnet striker, so it can be easily attached with a bolt-on method.
■When installing, be sure to adjust the left/right and front/rear clearances as well as the height from the left and right fenders.